vB Easy Archive - VX7000 and bitpim on Linux

Pages: 1

VX7000 and bitpim on Linux - AT$QCDMG not working?
(Click here to view the original thread with full colors/images)

Posted by: balmeida

Has anyone been able to get the VX7000BK to work on Linux with bitpim (I tried 0.7.26).

I'm running Debian unstable with kernel 2.6.10 - the phone is detected by the cdc-acm module and I can do commands in minicom fine (115200 8N1, I set the diag interface to this in the service menu as well) but it fails to go into diagnostic mode (gives error when AT$QCDMG is issued).

I am using the USB charging cable from RPI Wireless.

Strangely, the phone works fine on my MacOSX powerbook. Does Linux do things differently from mac? Any thoughts/ideas?

From syslog:
usb 3-1: new full speed USB device using uhci_hcd and address 11
cdc_acm 3-1:1.0: ttyACM0: USB ACM device

From lsusb:
Bus 003 Device 011: ID 1004:6000 LG Electronics, Inc. VX4400/VX6000 Cellphone

From bitpim's protocol logs:
8:08:32.036 /dev/ttyACM0: Changed port speed to 115200
8:08:32.536 LG-VX7000: brew request Data - 2 bytes
<#! p_brew.memoryconfigrequest !#>
00000000 59 0c Y.

8:08:35.536 /dev/ttyACM0: Timed out waiting for 7e, requested bytes 1 - 0 bytes read
8:08:35.587 /dev/ttyACM0: Incomplete read was Data - 0 bytes

8:08:35.638 /dev/ttyACM0: Writing Data - 8 bytes
00000000 41 54 2b 47 4d 4d 0d 0a AT+GMM..

8:08:35.693 /dev/ttyACM0: Reading remaining data Data - 28 bytes
00000000 41 54 2b 47 4d 4d 0d 0d 0a 56 58 37 30 30 30 20 AT+GMM...VX7000
00000010 20 31 30 35 0d 0a 0d 0a 4f 4b 0d 0a 105....OK..

8:08:35.694 /dev/ttyACM0: Writing Data - 10 bytes
00000000 41 54 24 51 43 44 4d 47 0d 0a AT$QCDMG..

8:08:38.700 /dev/ttyACM0: Reading remaining data Data - 18 bytes
00000000 41 54 24 51 43 44 4d 47 0d 0d 0a 45 52 52 4f 52 AT$QCDMG...ERROR
00000010 0d 0a ..