vB Easy Archive - Just A Quick V3i Battery Cover Question! FAST HELP PLZ!!!

Pages: 1

Just A Quick V3i Battery Cover Question! FAST HELP PLZ!!!
(Click here to view the original thread with full colors/images)

Posted by: thetoy88

I know this sounds a bit stupid (but bear with me)

So my new v3i razr just arrived and i'm trying to put on the battery cover when i place the little "piece" of plastic on the bottom of the battery cover into where it's suppose to go, then i "click" the cover into place...one side of the battery cover always seems to be not fully on, no matter what i try...

..so basically i was just wondering if you were supposed "click-it" into place then just push down on the one side that's still up and it will go down with a push (without breaking anything)...

just wondering if this is normal (or if i got a bad bettery cover or sumthing)...and if you just "click it" into place (ie. it wont break when you do that)..

thanks in advance hope somebody knows what i'm yapping about in my post and can just help me fix this and clarify things thanks!!!

Posted by: RedSox

I have experienced the same thing with one of my v3 razrs. If you look on the inside of the battery door, it shows a diagram of how to install the door. You'll see that it actually tells you to push the corners of the door down to click it in place. I'm not sure whether the V3i has the same diagram or not.

Posted by: thetoy88

Quote:

Originally Posted by RedSox

I have experienced the same thing with one of my v3 razrs. If you look on the inside of the battery door, it shows a diagram of how to install the door. You'll see that it actually tells you to push the corners of the door down to click it in place. I'm not sure whether the V3i has the same diagram or not.

ya it was the same diagram showing to push the corners on as step #3...just trying to comfirm that...did you do that with yours and it work ok (ie no brakage or anything) thanks again

Posted by: cyberpac9

Quote:

Originally Posted by thetoy88

ya it was the same diagram showing to push the corners on as step #3...just trying to comfirm that...did you do that with yours and it work ok (ie no brakage or anything) thanks again

i have two razrs, both of which have a battery cover that is slightly "off" on one side...causes no problems, plus i've seen others on here with the same issue...i figured no big deal until something bad happens because of it....i wouldn't worry too much, as long as it stays closed and doesn't appear broken...

Posted by: thetoy88

found the answer lol! ...you do have to "push" on the corners a bit to get it to fit right...at least i had to anywayz

Posted by: Däch

I also had to push kinda hard to get mine closed. At first it seemed like I had to push "too hard" to get it to go on properly. At least I know the back isn't ever going to fall off.