Problem With Motorola V9m EVDO

[tjienan]

I have Motorola V9m by US Cellular and I am using it to other carrier. I did all setting and they work just fine. Except one thing, I am using QPST to change the PPP CONFIG tab UM, when I write the TETHER NAI , USER ID and PASSWORD.......it went back to the default @uscc.net !

What should I do to fix this issue? I already do searching but they were just dead end

[bob_the_tomato]

Don't know if you still need help, but you need to do a couple of seem edits:
Seem 275a offset f4 - set HEX to 04 (only check bit 2)
Per step 3g on this guide:
http://mark.cdmaforums.com/USC-V9M-Monster1.htm
(Though it is much easier to use p2k05seem than to use radiocomm as shown in the guide. p2k05seem did not yet exist when that guide was written.)
First posted here:
http://www.howardforums.com/showthre...0#post10089650

And, fixing these two seems should fix things so *228 will work properly:
http://www.howardforums.com/showthre...Solution-Found

Of course, if you're not using Verizon's network, you'll need to put in something other than vzw3g.com.

Good luck!