Test mode for G'zOne Ravine?

[dlabrie]

Can anyone tell me how to get into the test mode and check signal strength on my Cassio G'zOne Ravine?
Thanks

[XRAM]

##8378 send

[dlabrie]

XRAM Thanks. I thought once I put it into fieldtest mode that I would be able to choose "signal Strength"But that does not show up. Can you tell me how to bring up the signal strength?

[XRAM]

No problem.....Go to the debug screen.

[dlabrie]

When I go to the debug screen I just get a blank page.

[XRAM]

When I enter ##8378 send and select debug screen I get all the info to show up.

[moto94536]

I also did ##8378, select debug screen. it show blank.

[XRAM]

That is odd. I just checked it again and the test screen shows up fine for me.

[dlabrie]

I have been talking with Wilson electronics about getting a signal booster. They said

Unfortunately, we do not have the instructions for putting that particular model of phone into test mode.

So I fired up an old LG5500 and tried these instructions

Press Menu 0. Enter Service Code: 000000 (six zeros). Scroll to FIELD TEST. Press SELECT. Scroll to SERVICE or SCREEN. Press
SELECT. Signal strength is on the line that says RX Level. On some
newer phones you need to make a phone call while in test mode to get
the numbers to update. To exit test mode press CLEAR, END or turn
the phone off and on. (Note: On some models you will need to take the
battery off and put it back on again.)

there is no menu 0 command. so I struck out there as well.

[Dave Lister]

If hitting 0 after the menu button didn't work, try *.