Reply With QuoteYou forgot the replace the vibration motor, which is attached to the inside-bottom of the faceplate. Just pry it out, and pop it in to the new faceplate.
|
|
|
|
|
Phone Collector
Any idea's? Can't figure out why it would make a difference or not. Guess I could swap back in the old face plate but wouldn't be able to do it for a couple of days. Just figured I'd post up and try to get some idea's on what might be going on.
My antenna is smaller than yours
You forgot the replace the vibration motor, which is attached to the inside-bottom of the faceplate. Just pry it out, and pop it in to the new faceplate.
Phone Collector
No s**t!!??Originally posted by dtemplar
You forgot the replace the vibration motor, which is attached to the inside-bottom of the faceplate. Just pry it out, and pop it in to the new faceplate.Thanks! I would have never known about that
Phone Collector
Got it working now! Thanks for the advice!
The HoFo Hitman
hehe, i did that once, then i threw out the old faceplate and screwed myself...that was way back in my n00bie days.
Phone Collector
Well I'm a newbie and not ashamed to admit it.Originally posted by fobile
hehe, i did that once, then i threw out the old faceplate and screwed myself...that was way back in my n00bie days.
I've climbed a cellphone tower
I accidently threw out one of the little plastic O-ring washers that go on the screws attaching the faceplate. Also didn't quite get the sticker antenna put on the phone the first time. Didn't think I could remove it and put it on again but luckily it did.
Bookmarks